Cartridge JK55 55X8002-09-1 1118010FA130 JAC 4DA1

After the installation

To test, crank the engine for 10 – 15 seconds to prime oil feed without starting the engine.
Start the engine and let it idle for 3 to 4 minutes to allow for proper inspection of oil, gas and air leakage.
If any leakage is detected during engine start up, please fix the issue immediately.
For VNT turbos, please ensure that actuator operates correctly after starting up. During vehicle key-on and start-up, it is normal for VNT turbos to show movement in actuator, vane arm and vane mechanism, and it is also normal to hear a high-pitched noise from electric actuators.

If no movement is detected, please investigate the cause on the vehicle, as the actuator operations has been set and tested before it left our factory.

Important Note: The gears in our electronic actuators are “self-blocking”; this means that it is not possible to move the actuator operating arm or the connecting rod manually. Attempting to move these parts with a tool or by hand may break the gears and make the turbo unusable. Damage of this sort is not covered by our warranty.
Finally, stop the engine and re-check engine oil level. It is important to make sure that oil level is between the minimum and maximum levels allowed.

When will I get my cargo?
Express-3 to 8 days after on board;
Truck- 1-15 days after on loading;
 Air- Around 7 days after on board;
Sea- Around 15 Days to 60 Days after on board.
All depend on where you located in.